LogoControl + Arduino + IP Camera

[fabmop90]

Regards

I’m Fabian and I writing you from Ecuador, I had used the LOGO for control the lights in my house, and to automatize the water pump. But I have a problem for to control the temperature in the shower (two electric showers), I want to controller this using Solid State Relay (SSR) with zero crossing for cut the wave and so to control the temperature, for this I want use ARDUINO with ETHERNET but controlled by LOGO-CONTROL I want send a number (0 to 100) for generate a PWM for to activate the SSR, my problem is that I using LOGO in AC voltage and I can´t use analog module.
The IP Camera is for monitoring the door of outside when I activate the option Camera in LOGO-CONTROL.
Thank for your answer and I apologize for don´t write in German and my English is not very good.

Fabian
Manta-Ecuador

[Autor]

Beiträge